Sensor Swab Plus Type 2 4 Pack
SENSOR SWAB Plus is a one-step cleaning process guaranteed not to damage your sensor. SENSOR SWAB Plus is pre-moistened with ECLIPSE fluid. Comes in three different sizes.
SENSOR SWAB Plus is your one step cleaning process. Each swab is pre-moistened with ECLIPSE fluid.
SENSOR SWAB Plus is designed for cleaning CCD/CMOS chips and other delicate or hard to reach optical and imaging surfaces. These swabs are available in three different sizes. The swabs are manufactured and sealed in a clean and sterile environment; therefore, these swabs are the ultimate in purity.
How to use SENSOR SWABS PLUS?
Review your camera’s manual to learn how to expose the sensor. Once the sensor is exposed, tear open the packet at notch. Do not remove the swab from its sealed packet until you are ready to use it. Once ready, remove swab and insert into the camera’s chamber (you want to make sure that the swab makes contact at either the left or right edge). Use firm pressure so the swab handles bends. Smoothly and firmly wipe the swab across the sensor. Without lifting the swab go back in the opposite direction and use the other side of the swab. Remove the swab from the chamber and discard. Dirt on the swab can scratch the sensor, so always remember to discard swab after use.
When used as directed SENSOR SWAB Plus is easy and safe to use and yields excellent results! SENSOR SWAB Plus is recommended by most camera manufacturers and is guaranteed not to damage your sensor.
SENSOR SWAB Plus is “as easy as one and done”!